ProSeal™ Bulb Seal Garage Door Bottom Seal
1. Remove existing garage door bottom seal. Some garage door manufacturers will pinch the aluminum track to hold the bottom seal in place. To open a pinched track, insert a flathead screw driver, into the end of the track, and gently pry open the end, just enough to allow removal of the old door seal. Both ends of the track may need to be opened.
2. Make sure any debris in the track has been removed and that it is clean and dry.
3. Starting at either end of the garage door, insert the T-End, attached to the ProSeal™ Garage Door Bottom Seal, into the track. Next, slide the ProSeal™ into the track, until it reaches the opposite side
Note: In order to keep the ProSeal™ securely in place, the T-End has been manufactured slightly oversized. To make installation easier, apply liquid soap to the T-End.
4. Using a scissors, trim off the excess ProSeal™. If your door seal track was pinched and you wish to pinch it back together, use pliers to gently pinch the track back into place.
***To ship the Bulb Seal, it has been flatten and rolled into the box. Once installed and used over time it will regain its original shape.